I am not a web designer, I was a developer so I will not even try to make this look pretty but I will warn you:
NOT FOR LOW BANDWIDTH CONNECTIONS!!!
Some pictures on here are from my camera others are from my phone so don't expect the best quality on all of the pictures. I will upload more pictures if and when I take them. The system I have installed in my truck is listed below.
Status: Installing and Configuring Hardware (Incomplete)
Installing and Configuring Software (Incomplete)
Tuning Sound System (Incomplete)
Detailed Specifications:
Front End: Centrafuse v2 Nav
OS: Windows 7 RC1 Build 7100
Motherboard: Intel BLKDG45FC
Processor: Intel Core 2 Duo E8400
Memory: 4GB (2 x 2GB) DDR2 800
HDD-1: 200GB 2.5in SATA II (3Gbs)
HDD-2: None
PSU: M2-ATX 160W Intelligent DC-DC PSU
Sound Card: Integrated
Screen: Lilliput 8'' Wide screen
Car/Accessory Control: None
Satellite Radio: None
HD Radio: None (MP3Car HD Radio Coming Soon...)
WiFi: 802.11n Wireless USB
EVDO: Bluetooth to Cell (LG Dare)
OBD: ElmScan 5 USB OBD-II Scan Tool
GPS: BU-353 Weather-proof GPS Receiver
The truck (front)
The truck (back)
ElmScan 5 ODB-II Scanner (USB)
GPS and XM antennas mounted on the rear right side of the top of the truck
(XM no longer used)
Front mounted B/W CCD Camera
Front camera video and power wires
Front mounted power and accessory distribution with 4 Port USB hub from MP3Car (right)
Power mounted to the battery with a battery adapter like THIS ONE from streetwires with a power ring like THIS ONE both are 4AWG
Power and ground 4AWG , run through the floor and underneath the truck
Grounding point on the frame (now it is more securely mounted and painted)
Underside of power and ground
Left side of front and middle channel amp along with power and remote wires
Core 2 Duo E8400 with 4GB of G.Skill Memory
Mini bluetooth dongle and eSATA to the back panel (now hidden under 4 USB cables)
Backside of the Speakon audio connectors for front, middle, and rear speakers with a center channel RCA
(Only the front and middle channels are wired in this picture)
Backside of the USB connectors with the DCL11 15w PSU @ 9v to power the VGA extenders
Power distribution and control wires
(Pictured relay is no longer used, remote wire is directly connected)
Dual ethernet cables with Neutrik protective casings (black = VGA over cat6, blue = control wire)
Inside look at the Neutrik case
Kicker DCVR12 Car Audio COMP CVR Dual 12" Sub Enclosure 2 Ohm
Testing...
Close up of carpeting
One of four mounts for the subs
Getting the subs carpeted in
Nearly finished system ready to be installed in my truck...
Almost done...
Done!!!
Subs with custom box mounted in my truck
If you would like to comment click here. (Forum registration required to post)
